Soon it will be time to install Watermark Sensors

Drew Gholson, Irrigation Specialist
By Drew Gholson, Irrigation Specialist and Dan Roach, Ext. Associate April 29, 2021 09:36

Soon it will be time to install Watermark Sensors

Related Articles

Latest Tweets

I’m sure irrigation is the last thing on most folks minds but here are some things to consider to prepare for irrigation season this summer. Watermark soil moisture sensors are probably the most widely used sensor here in the Delta. Watermark sensors have a useful life of approximately five years per Irrometer’s web page. Considering the time and effort it takes to replace a bad sensor after installation, dated sensors should be discarded and replaced with new sensors. The MSU Irrigation Team routinely inscribes with a permanent marker the date the sensors are put into service. This allows us the opportunity to discard old watermark sensors before they become a problem.

 

Pre-conditioning of the Watermark sensors is a must!
Watermark sensors must be pre-conditioned prior to installation. To pre-condition, slowly wet the sensors by partially submerging them (no more than half way) in water for 30 minutes in the morning, let dry until evening, wet for 30 minutes, let dry overnight, wet again for 30 minutes the next morning and let dry again until evening. Soak over the next night and install WET. Sensors must be installed wet. Pre-conditioning the sensors ensures quick response to changing soil moisture conditions. If a sensor is only soaked and then installed, several irrigation cycles must pass before it will respond accurately.

 

Watermark Sensor Multi-Depth Profile Probe.
Multiple WATERMARK sensors can now be installed on a single piece of PVC pipe utilizing the relatively new 200SS-5-S type sensor. The 200SS-5-S sensor is constructed with the mesh sensor located between two spigot ends for mounting to the PVC pipe. The MSU Irrigation Team suggest you utilize this technique for the 6″ and 12″ sensors. We encourage to to try a couple 6″, 12″, and 24″ combinations, but we have had issues installing and retrieving the combination sensor at the 24″ depth. More information can be found at the Irrometer web site, https://www.irrometer.com/downloads.html#200ss   Under Support Material click on the Pipe Install-Single and Multiple Depth Manual.

Print Friendly, PDF & Email

Drew Gholson, Irrigation Specialist
By Drew Gholson, Irrigation Specialist and Dan Roach, Ext. Associate April 29, 2021 09:36
Write a comment

No Comments

No Comments Yet!

Let me tell You a sad story ! There are no comments yet, but You can be first one to comment this article.

Write a comment
View comments

Write a comment

<

Subscribe to receive updates

More Info By